EXTERIOR
Anchoring Hardware
- Stainless Steel double chain rollers on Gammon
Hull, Deck and Rudder
- Fiberglass hull and deck structures described in Falmouth Cutter Fabrication Process
- Fiberglass foam cored rudder
- Bronze Pintle and Gudgeon set with Nylatron bushings
Navigation
- Compass (Ritchie BN-202)
Ventilation and Natural Lighting
- Six 6″ bronze Portholes
- Scuttle Hatch hinges both fore and aft to act as a wind scoop
Woodwork
- All exterior wood is Honduras Mahogany. It includes two drop boards, two handrails, eyebrow, taffrail, bulwarks, rudder cheeks, boom gallows and bitts. The tiller is laminated ash and the bowsprit is vertical grain Douglas Fir. The two hatches are fiberglass.
- Two HM deck boxes on both sides of the mast hold two aluminum Propane tanks.
- All exterior wood has two coats of teak oil. Bowsprit and tiller have 3 coats of varnish
RIG
Mast and Boom
- LeFiell Aluminum Mast and boom with single spreaders
Running Rigging
- All teak blocks
- Two bronze Lewmar B16STB self tailing Jib sheet winches
- Two bronze Lewmar B8B Staysail sheet winches
- All solid Bronze winch cleats
- Two bronze Lewmar B8B halyard winches with double rope clutch
- Two winch handles provided
Standing Rigging
- 1 x 19 Sailbrite 316 stainless steel rigging with chrome plated bronze turnbuckles with swages
Sails
- Mainsail, 153 sq. ft., 6.9 oz. Dacron
- Jib Top, 154 sq. ft., 6.9 oz. Dacron
- Staysail, 81 sq. ft., 6.9 oz. Dacron
- Halyards and sheets
- Mainsail cover

INTERIOR
Forward Cabin
- Double berth forward with insert
- Hanging lockers lined with aromatic cedar strips
- Vanity bench
- Groco head with Henderson pump for holding tank
- Holding tank, 9 gallon black polyethylene
Galley Area

- 45 gallons of water (two – 9 Gal, 1 -27 Gal Polyethylene Water Tanks) are set under the cabin sole and adds to the ballast
- Stainless steel galley sink (10″ x 14″ x 8″ Deep)
- Whale Gusher foot pump for salt water to galley
- Brass Fynspray pump for fresh water to galley
- Galley cutting board and work surface between sink and ice box
- Propane Stove, Force 10 – 2 Burner w/Oven
- Icebox with 3-1/2″ insulation
- Fiddle behind sink prevents water running into lockers
General
- All cushions, material of your choice
- Insulated under cabin, decks and hull sides to waterline
- Laminated Ash tiller
- Henderson manual bilge pump in cockpit area
- All chain plates, tangs, cranse iron, gammon iron, Plates, etc. are 304 stainless steel
- Bronze companionway lock
- Delrin fid holds retractable bowsprit in place
- Solid cast bronze hawse holes
- Bronze boom gallows knees
- 3/4″ bronze Gudgeons and Pintles
- Single lifelines with gates port and starboard
- All bronze hatch hardware
- 10.4# Aluminum Propane tank in deck

Saloon and Quarter Berths
- Table slides out over engine compartment
- Quarter berth on port and starboard side with ample storage lockers behind and at the aft ends
ELECTRICAL
- Electric bilge pump with float switch
- Alpenglow light in Galley
- DC Panel, 12 breakers
- Radio ground strap bonded to lead ballast
- 6 ABI Interior Lights
- Two series 24 Gel marine batteries in Lazarette
- Steaming Lights (P&S) on Mast Below Spreaders
- Tri Color and Anchor Light Combination

ENGINE
- Yanmar 1 GM 10 hp Diesel
- Racor Fuel Filter in addition to engine filter
- Engine Controls, Morse Control
- Dripless Shaft Log
- 1/8″ welded aluminum 15 gallon fuel tank
- Two blade bronze prop, 14″ X 10″ RH