FC Forum : Sam L. Morse Forums
News, views and discussion on the Lyle Hess designed Sam L. Morse Falmouth Cutter
Goto Thread: PreviousNext
Goto: Forum ListMessage ListNew TopicSearchLog In
Bronze bits for the FC
Posted by: Hypothetical (IP Logged)
Date: December 10, 2013 01:39AM
Category:

So, I finally finished making the parts for the Falmouth Cutter I had and sold. The stem fitting was very recently replaced in stainless, but all the other parts were just made.

Made from flat stock silicon bronze, utilizing bandsaw, sander/grinder, buffer/polisher, TIG welder, drill press, and a hydraulic press with broach.


Attachments: FC Bronze bits.jpg (97kB)  


Sorry, only registered users may post in this forum.
copyright Coledata, Inc. 2008